Description
SECO Development platform Q7 Dev-Kit-2.0
This platform requires the addition of the Q7 or µQ7 module used for development
Multiplatemeal development kit for QSEVEN® philosophy, compatible with QSEVEN® X86 and ARM REV. 2.0The new Multiplateforme 2.0 development kit is based on the CQ7-A30 carrier card, born from the SGET consortium specifications. The package is a complete set of equipment that you must develop with the QSEven® processor modules in X86 and ARM architectures, and above all, explore the possibilities offered by these two different worlds. This is due to the possibility of going from one architecture to another at any time, with just a few small software changes and a minimum of effort and time.
| Video Interfaces | HDMI / Display Port Interface on PCI-E X16 Slot LVDS / EDP Interface on PCI-E X8 Slot |
| Mass storage | SATA FEMALE 7P Connector With Dedicated Power Connector, Shared With Msata Slot Interface SATA MALE 7+15P Connector SD / Mimic Card Slot Spi Flash Socket I2C Eeprom Socket |
| Networking | Gigabit Ethernet Connector |
| USB | 1 x USB 3.0 HOST Type-a socket 1x USB 3.0 OTG Micro-Ab socket 1x USB 2.0 Host Ports On Internal Pin Header (Alternative to USB 3.0 Port #0) Up to 4 x USB 2.0 Host Ports on Quad Type-A socket |
| PCI-E | PCI-E X4 ON DEDICATED PCI-E X16 Slot Shared with 3 x PCI-E X1 slots + minipcl-e slot (selection via jumper) |
| Audio | Embedded HD Audio Codec, Realtek ALC888 2 x triple HD audio jacks 2 S / PDIF Connectors (IN & OUT) Slot expansion audio |
| Serial Ports | CAN Bus (Both TTL Interface and with can transceiver) 3 x RS-232 Only ports 2 x RS-232 / RS-422 / RS-485 configurable serial ports |
| Other nterfaces | Feature Connector, With 12C, SM Bus, Watchdog, Thermal and Power Signal management LPC Bus Header Spin pine header Sim Card Slot 4 x 7-segment LCD Displays for post codes PS / 2 Mouse / Keyboard Pin Header 2 x Tachometric Fan Connectors Debug Port on Mini-B Usb Connector Power, Reset, Lid and Sleep Buttons |
| Power Supply | +12V DC Coin Cell Battery Holder for Cmos and RTC |
| Operating Temperature* | 0 ° C ÷ 60 ° C |
| Dimensions | 345 x 170 mm (13.58 "x 6.69") |
