Description
Development kit for SMARC SECO modules (SMARC DEV KIT), compatible for modules with Arm or X86 architecture
The development kit includes the following equipment:
- CSM-B79 reception card
- Connector adapter cable (free wires at one end)
- Serial adapter cables
- Optional display pack (EDP or LVDS)
- 1x SATA power cable
- Main sector adapter cable
- 1x High speed DP cable certified according to DP1.4
- 1 HDMI Certified HDMI cable according to HDMI 2.0 standard
- DP-HDMI adapter
The module is not included, it must be purchased separately.
| Video Interfaces | LVDS Connector, Shared With 2 X EDP/DSL Connectors interface Backlight Control + LCD Selectable Voltages Dedicated Connector DP ++ Dedicated Connector HDMI Connector (Shared With USB 3.1 Type-C Alternate Mode Port) 2x CSI Camera input interfaces |
| Mass storage | SATA M 7P Connector With Dedicated Power Connector, Shared With M.2 Socket 22242 /2260 Key B SSD SLOT MicroSD CARD SLOT |
| Networking | 2 x RJ-45 Gigabit Ethernet Connectors M.2 Socket 2230 Key E Slot for Wifi Modules (Shared With PCI-E X 4 Slot interface) M.2 Socket2 2260 Key E Slot for Wwan MoDem Modules (Shared With PCI-E X 4 Slot interface), Connected to on-board microslm slot |
| USB Ports | 1 x USB 3.0 Type A socket 1 x USB 2.0 Type A socket 1 x USB OTG Micro-Ab socket 1 x USB 3.1 Type-C Socket, With Alternate Mode and Power Delivery Functionality |
| PCI-E | PCI-E X4 Slot, Shared interface with 2 x PCI-E X1 Slot and M.2 Slots |
| Audio | Mic in jack, line out jack Onboard I2S Audio Codec (TL TLV320ALC3204) + HD Audio Codec (Cirrus Logic CS4207) |
| Serial Ports | 2 x CAN Ports 2 x RS-232/RS-422/RS-485 Configurable serial ports on internal pin header 2 x serial ports (TX/RX signals only, ttl level) on feature pin header |
| Other interfaces | ESPL PIN HEADER + FLASH SOCKET Spin pine header + flash socket I2C Eeprom Socket 4 x 7-segment LCD Displays for post codes Feature pin header with 8x gpios, i2c, sm bus, watchdog and power Signal management 4x GPIOS DEDICATED CONNECTOR Fan Connector RTC Coin Cell Battery Holder Optional Debug USB Port on Mini-B Socket Boot Selection Switches JTAG Connector |
| Power Supply | 9-21V Through dedicated mini-fit JR 2x2 Power Connector or USB Type-C Connector 6-17V Through 2/3/4 Cell Smart Battery Connector |
| Operating Temperature* | -40 ° C ÷ +85 ° C |
| Dimensions | 243.84 x 243.84mm (microatx) |
